M01 - WHAT THE MATERIAL INPUTS CAN AND CANNOT TEST The frozen MATERIAL-INPUTS.json provides three E/rho/nu sets for the same homogeneous, isotropic, small-strain solid. Changing these properties can change its elastic stiffness, inertia, natural frequencies and forced displacement/stress response under the declared geometry and boundary conditions. It does not establish whether the material will fracture, or which physical actuator can deliver the prescribed force. Hardness describes resistance to a specified indentation or scratch test. It is not an elastic resonance parameter. Elastic modulus describes reversible stress-strain stiffness. Strength depends on the specified loading/failure criterion. Fracture toughness concerns resistance to crack extension and requires an appropriate crack/test definition. These are separate quantities; no universal hardness-to-resonance or hardness-to-fracture conversion is used here. NIST's indentation research treats modulus, hardness and toughness as distinct properties, with method, rate and microstructure limitations: https://www.nist.gov/publications/probing-material-properties-sharp-indenters-review https://www.nist.gov/publications/modeling-simulation-and-prediction-rockwell-hardness-indentation https://www.nist.gov/publications/fracture-toughness-data-brittle-materials Hydro's source lists different hardness values for6061-T4 and6061-T6 while giving approximate E and Poisson ratio for the6xxx family. That illustrates why changing a hardness label alone cannot supply a new linear-elastic stiffness tensor. No hardness values from that table are used to create a crack law. Source scope - ArcelorMittal: generic structural-steel coefficients, not an identified certified heat or individual grade. The source table does not explicitly state elastic-property temperature. - Hydro: EN AW-6061 identity and density table; E and nu are explicitly approximate common6xxx-series values. The thermal-conductivity row states20C, but the elastic block does not. Do not silently promote that into an exact measured elastic temperature. - Corning: the HPFS table states25C. Fused silica is amorphous glass. Crystalline quartz requires crystal orientation, an anisotropic elastic tensor, and, where relevant, piezoelectric coupling. Diamond also cannot be represented faithfully simply by changing a hardness number. These catalog inputs are rounded. E and nu should determine the other isotropic moduli internally; independent rounded catalog shear/bulk columns are not additional constraints. Damping is a separate illustrative assumption here, not a manufacturer measurement. Temperature-dependent moduli, thermal expansion/stress, inelasticity, damage, grain boundaries, flaws and fracture remain outside this baseline. A three-dimensional mesh is a genuine3D discretization only if the solver carries three displacement components at each spatial node and the complete3D strain/stress law. Merely extruding a picture or animating one beam coordinate is not the same test. Mesh convergence, boundary sensitivity, eigenpair residuals and forced-response convergence are numerical evidence. Physical confirmation still needs measured dimensions, supports, material properties and response. The equation reference is the FEniCSx tutorial's small-strain isotropic stress law and weak form: https://jsdokken.com/dolfinx-tutorial/chapter2/linearelasticity.html This is a formulation reference, not independent certification of the new implementation. M01 author and reviewer tests remain separate. All vendor material remains at the linked primary sources. This note redistributes no vendor PDF, image or table.