E01-I / CAPTIVE GRAVITY CARTRIDGE — ONE-IMPACT REFERENCE Status: unbuilt, manually reset/released. It is not a motorized repetitive exciter. No load-bearing strength, friction, timing, contact or capture material is tested. CoordinateZ is upward; physicsdownwardx=-Z. Target tip datumZ0. Flat baseunderside isZ0. The target/specimen fixture and cantilever registration are NOT supplied. 1. Qualify material and fit coupons. Cut/select twoØ4x120mm metal guides. Machine or procure exactly documented sleeves:ID4.1,OD6barrelL14,OD8flangeL1. These are nominal custom sleeve drawings; no supplier running-fit certification exists. 2. Assemble moving group: insert headed tip from above into the carriage seat; tip is4mmstem/R2nose/8x3head. Place8mm-long keeper spacer atop head. Insert both flanged sleeves into their1mm top counterbores. Fit full-width3mm retainer. Two nominalM2x18 countersunk screws andM2nuts retain it. Nuts fit lower-open pockets; screw supplier countersink geometry must match the stated reference. 3. Weigh EVERY moving item including tips, sleeves, retainer, screws and any added sensor/wire. Nominal12g is a model input, not a demonstrated CAD mass. Maximum admissible complete moving mass is20g for the stated energy ceiling. 4. Fit guides into the base blind bores. Slide the moving assembly onto them. Fit upperkeeper and4M3x20 screws/washers/nuts. Uppernut traps are accessible from outside the side columns before closing. Keeper undersideZ120 limits moving retainer top at tipZ90. Test actual free sliding/breakaway before release. 5. Fit two3mm capture pad templates over the guide-relief notches onZ7 base. Pad stiffness and loss are UNKNOWN. They engage when tip reachesZ-2; hard shoulder atZ-5 is an independent geometric retention limit. A model trajectory hitting this boundary FAILS, even though the carriage remains geometrically captured. Select/capture actual pads and qualify bonds/retention separately. 6. Fit frontcover using4M3x16 stacks. Use the rear lift tab/slot for MANUAL reset. PinaxisX7.5,Z95.5 supports carriage underside atZ97, setting tipreleaseZ85. Insert the3mm metal releasepin, then remove hands from the moving path. Its reference handle withdraws at least35mm towardnegativeY to clear the carriage. The pin is manually removable; its external tether/retention remains a gate. 7. Register flat reference target atZ0 using a separately designed fixture. No universal boulder/diamond/log clamping is represented here. The current geometry is a small coupon-level mechanism reference only. ENERGY: nominal12g×g×85mm=10.002783mJ to target absent guide loss. Total worst release-to-hardlimit budget20g×g×95mm=18.632635mJ, below20mJ. Post-contact gravity work is included. No spring preload is permitted by this energy calculation. No printed component strength, successful capture or actual impact efficiency is proved by that arithmetic. Friction exceeding0.1176798N can hold a12g slider. MODEL/CAD BOUNDARY: base aperture18×20mm is smaller than the36mm carriage, so gross axial exit is geometrically blocked. Upper and lower overtravel negatives are tested. Six sampled travel positions are checked for nominal interference; this is not a continuous manufacturing-tolerance proof. Rods, screws and metal tip are not printable substitutes. The powered reset/release/control interface is an unimplemented later scope, not an operating automatic-BPM feature.