E01-A / ND64-4 SEALED ACOUSTIC HEAD — DIGITAL ASSEMBLY REFERENCE Status: unbuilt. This is a mechanically detailed nominal design, not hardware acceptance, a certified acoustic source, a fracture device or proof of no-solder compatibility. Confirm all open gates before fabricating the full assembly. Coordinate datum: X horizontal, Y up, Z toward listener. Boxfront Z0; baffle rearZ1/frontZ9; driver rear-mountfaceZ10; grille undersideZ27. Units mm. 1. Make the supplied process-fit coupon and driver-pattern gauge first. Measure holes, nut traps, actual driver flange thickness and all terminal projections. Supplier drawing nominal4.2mm holes sit on66mm PCD at45degrees. The assembly usesM3 screws and3.4mm custom clearances; no positional tolerance is qualified. 2. Select actual threaded hardware against the reference envelope. Body nuts enter rear-open traps before closing the baffle. Driver/grille nuts enter the rear baffle pockets while accessible. Fit keeper adhesive/retention if needed only after material evaluation; none is assumed in the CAD load qualification. 3. Attach benchfoot with4 M3x25 screws, outer/inner washers andM3nuts. Bolt heads are under the foot; internal nuts remain reachable while the box is open. 4. Fit the assumed6mm-bore/6mm-wall/4mm-cable grommet. Route actual speaker cable through it and beneath the rear two-screw clamp. Clamp uses2M3x16 screws, washers and nuts. The nominal groove permits0.1mm cable compression; actual cable retention, insulation pressure and acoustic seal must be measured. 5. Mount ND64 driver on1mm gasket using4M3x12 screws/washers/nuts. Current bolt length permits full nominal nut engagement over assumed flange0.8..2.0mm. This range is a design assumption, not a published flange tolerance. 6. Connect driver to an external compatible amplifier with verified connectors. Terminal/tab dimensions are unknown; no solder-free purchase compatibility is established. Keep internal wires clear of cone/basket and seal every cable path. 7. Close box using the1mm perimeter gasket and4M3x30 screws/washers/nuts. Do not infer mounting torque from CAD. Measure gasket compression and leakage. 8. Mount grille on its four18mm standoffs with4M3x30 stacks. Nominal grille underside is10.8mm beyond manufacturer front projection plusone-wayXmax. This clearance calculation is not a fragment-rated protective guard. 9. Benchmount only after the chosen material/load path is independently checked. Begin electrical/impedance/leakage characterization with the separate bench protocol and record actual net cavity volume. Do not assume a rated power value establishes continuous safe operation in this custom enclosure. AIR VOLUME: use E01-A-VOLUME-v2.json. Net0.7039780004475063L is a Boolean reference volume. The solid authored basket envelope overstates actual displaced air; terminals, wires, gasket compression and leaks remain unknown. It is not a measured acoustic volume or sound-pressure result. Fastener representations use smooth shanks and nominal heads/nuts. Buy threaded metal parts; do not print these references. Rear box, baffle, grille, cableclamp and foot are custom-part candidates. Gaskets are sheet templates. Allproposed polymers, sealing, support strategy and print orientation require qualification.